This guide is educational information, not personal medical advice. The source-check date records editorial work, not a clinician review. Read our medical disclaimer.

From the blood draw to the report

Before the sample is collected, ask whether the order is for a laboratory antigen/antibody test or a NAT and how the result will reach you. A laboratory test can take several days; the date the result arrives is not the same as the date the sample was collected.

A negative laboratory antigen/antibody result must be considered against the possible exposure date. CDC’s usual window for this test using blood from a vein is 18–45 days. If the sample was collected too early, ask about repeat testing. If you have used PrEP, PEP, or treatment, the provider may need a different follow-up plan.

A reactive laboratory screen usually triggers supplemental testing on the same sample. Ask if a result is pending, whether a new sample is needed, and who will explain the combined report. A screening line alone does not finish the diagnostic process.

Sources for this section: [1][2]

At the visit

A health professional collects a blood sample, usually from a vein. A laboratory antigen/antibody test looks for HIV antibodies and an HIV antigen. A NAT looks for the virus itself and may be considered in particular circumstances.

Ask the clinic what test was ordered and when you should expect the result. Laboratory turnaround may take several days, so make a plan for a private call or portal notification.

Microscope lenses above a slide.
A microscope is one of the instruments used in laboratories. Image: Kost9n4. Pixabay License. Cropped or resized for display. No medical condition or affiliation is implied.

Sources for this section: [1]

A positive screening result

If an initial laboratory test is reactive, the laboratory usually performs additional testing on the same specimen. The screening result alone is not the complete diagnostic process. Ask whether supplemental testing is pending and whether another sample will be needed.

If test results disagree or are unclear, follow the provider’s instructions for further testing. Keep a copy of the report and ask what each result means rather than trying to interpret an isolated line.

Sources for this section: [1][2]

A negative result and timing

A negative laboratory antigen/antibody result may miss a recent exposure. CDC’s usual window for this test using blood from a vein is 18–45 days; repeat testing after the window can be needed.

PrEP, PEP, and other antiretroviral medicines can delay detection. Tell the ordering clinician about recent use so the follow-up plan reflects your situation.

Sources for this section: [1][2]

Check the source

Sources & editorial note

We use the sources below to support this guide. Follow a source link for its full guidance and any later changes. Source checking does not replace medical review or a conversation with your care team.

  1. Getting Tested for HIV CDC. Accessed .
  2. HIV Testing CDC. Accessed .

Prepared by HIV Guide editorial team. How we write and check our guides · Contact and corrections information